Go Down
-
Squeaky Clean by GASlick on 15 May, 2008 09:24
-
I have recently noticed something. When I am in the shower shaving sometimes I will go over a spot again just to make sure everything is smooth. When I bring my fusion over a place that is already shaved IT SQUEAKS!
No kidding - my head squeaks. Crazy ain't it? Does this happen to anyone else? -
#1 by tomgallagher on 15 May, 2008 09:25
-
Yep, happens to me once in a while.
-
#2 by D.A.L.U.I. on 15 May, 2008 09:40
-
Me too, but I'm a sink shaver, and I think it's from all the "equipment" around the blade. I like it. Usually if I'm having a problem with a stubborn area, the base of my old cowlick I guess, I know it's gone when it squeaks.
-
#3 by fireman on 15 May, 2008 09:54
-
every once in awhile here. I think it does that to tell me I'm done
-
#4 by schro on 15 May, 2008 10:03
-
better change your oil.
-
#5 by R o b 6 on 15 May, 2008 10:17
-
I have recently noticed something. When I am in the shower shaving sometimes I will go over a spot again just to make sure everything is smooth. When I bring my fusion over a place that is already shaved IT SQUEAKS!
No kidding - my head squeaks. Crazy ain't it? Does this happen to anyone else?
I've noticed that, too, Slick!
I swap using Fusion and Mach 3, but have had that squeak deal happen. Let's not tell Gillette. They'll market it as a new feature...an audible, electronic reminder that you're done shaving, and tack on a few bucks to the cost of the blades!
-
#6 by JDog on 16 May, 2008 04:20
-
I've gotten the same thing before. It think it is from the rubber pad on the Fusion blade rubbing across the smooth skin on the dome.