Head Shaving, Grooming & Care > Face Shaving

YOUR face shaving routine

<< < (3/10) > >>

ycartt:
Same here...however, I just use a DE and not a straight razor.  Anything else and I get ingrown hairs.


--- Quote from: alabamalawyer on April 18, 2009, 12:41:07 PM ---I go the traditional route when shaving my face.  I use a shave brush and a shave soap or cream.  For a razor I use either a DE safety razor or straight razor.  My aftershaves vary but I typically use an alcohol-based aftershave followed by a light balm.

--- End quote ---

Danny:
I can shave my head with a rusty can and not get cut or razor burn. But I can buy the most expensive supplies for my face and get cuts, razor burn, ingrown hairs. I have a really sensitive face. I gotta shave reallllyyyyyy slow.

DaithiSean:
It all depends on how busy I am, but usually I lather up with saving soap and shaving brush and then do a second layer of head slick.  I then use a shaving brush to get a good lather all over my head.  I then shave head and neck against the grain and face and upper lip with the grain.  I then wash off any remaining soap and put a layer of aloe vera gel and head slick glossy.

edge:
Will start with electric razor for face to get all the bulk of growth cut down, then will shave dome with head slick using Mach 3 or Fusion.  Will then finish face with Sensor  blade and barbasol cream (aloe)as works well around goatee and top of ears, complete with clinique moisturizer on dome, neck, and face.  Mission complete.

HeadbladerBob:
I shower first then use a straight razor for the face.  I got sick of paying for all those expensive razor cartridges that promote bumps and iirritation more because of the numerous blades.   I use Noxema shave cream as it just works better for me

Navigation

[0] Message Index

[#] Next page

[*] Previous page